Test the new heating element by turning on the dryer and running it on a high heat setting. Reinstall the back panel of the dryer or any other parts that were removed to access the heating element compartment.Follow the wiring diagram in your dryer’s manual or on the back of the dryer to ensure correct wiring. Reconnect the wires to the new heating element.Make sure the element is positioned correctly and not touching the metal housing of the dryer. Carefully align the mounting holes and secure the element with screws. Install the new heating element into the compartment.Refer to your dryer’s manual or manufacturer’s website for guidance. Verify that you have the correct replacement heating element for your dryer make and model.Clean the area: Use a vacuum or cloth to clean any debris or dust that may have accumulated around the heating element.Depending on the model, it may be held in place with screws or clips. Remove the heating element: Once the wires are disconnected you can remove the old heating element.Carefully disconnect the wires that are connected to the heating element. Disconnect the wires: Take a photo of the wiring or make a diagram so that you know how to reconnect the wires.If it doesn’t have continuity, it will need to be replaced. If it appears fine, you can try testing it for continuity with your multimeter. If you see any signs of damage, such as cracks or breaks, it will need to be replaced. Take a close look at the heating element to confirm if it is damaged or broken. It is typically located near the bottom of the dryer, behind the drum. Once you have removed the back panel you should be able to see the heating element, which is usually a long, narrow metal tube or coil. Additionally, be sure to keep track of all screws and other fasteners you remove so you can easily reattach the panel once you’ve completed your repair. It’s important to be careful when removing the back panel as it may be heavy and can cause injury, or damage to the dryer. Once all screws and clips are removed, carefully lift the back panel away from the dryer.In this case, use a flathead screwdriver (or a putty knife) to move the panel away from the clips. Some dryer models may have additional clips or fasteners holding the back panel in place.Remove the screws from the back panel with a screwdriver.Locate the screws holding the back panel in place – they are usually located along the top and bottom edges of the panel.Move the dryer away from the wall to access the back panel.Replacement heating element – You’ll need a new heating element that is compatible with your dryer’s make and model, which can be ordered online.Work gloves – To protect your hands while working with electrical components.Pliers – You may need pliers to remove and replace wire connections and other components.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |